|
Instructions |
|||||||||||||
| Your Disc Repair Pro set comes with three different pairs of wheels:beige repair wheels, pink buffer wheels, and cleaning wheels. | |||||||||||||
| Repair Procedure | |||||||||||||
![]() 1. Insert the pink buffer units, rotate the units in a counterclockwise motion until secure. |
|
||||||||||||
![]() 3. Press the REPAIR button to begin the buffering process, which lasts approximately 2 minutes. The machine will automatically stop when buffering has finished. |
![]() 4.Continue this procedure by pressing the repair button for deep scratches. Very deep scratches may require up to 4 or more buffers. |
||||||||||||
![]() 5. Press open. Remove the beige repair units, from the repair protective kit and replace the buffer units with repair units. |
![]() 6. Rotate the repair units in a counterclockwise motion until secure. |
||||||||||||
|
7. Place 3 drops of the repair protective solution on the repair head marked wet which will create an anti-static protective layer on your disc. |
|
||||||||||||
|
|
|
||||||||||||
11.For extreme deep scratches, use the grey side of the super buffer tool. Rub from centre to edge and continue steps 1-10 above. |
|||||||||||||
Cleaning : For Cleaning use the cleaning wheels: |
|||||||||||||
![]() 1. Open the cleaning kit and remove the cleaning head marked "WET". |
![]() 2. Remove the plastic cover then use the plastic end of the brush to remove the cleaning head and the spring. |
||||||||||||
![]() 3. Add cleaning solution until the wheel is 80% full. |
![]() 4. Replace the spring and cleaning head. |
||||||||||||
5. Screw both wheels in place (WET wheel on the right side) |
![]() 6. Add disc, close lid and press the CLEAN button. The cleaning process lasts for about 20 seconds. |
||||||||||||
|
|||||||||||||